motor starting PTC thermistor
 
over current PTC thermistor
 
Motor start PTC thermistor pellet
 
overcurrent ,overload PTC thermistor for communica
 
heating PTC thermistor pellet
 
Degaussing PTC thermistor
 
suppressor
 
over heat PTC thermistor for temperature
 
exhaust temp. protector
 
sensor
 
NTC sensor
 
Protector for electric motors
 
·Add:No.5 Jinquan Road Langtou Town Zhenxing Zone Dandong China
·Fax:0415-6279501
·Code:118009
·Tel:0415-6279502
 


feature
1high voltage endurance
2good impact endurance
3long life span

4small residual current

5low power

6good flame-resisting

7safe and reliable



application range
appliancerefrigerator,air conditioner
motor
hothouse of train
dryer
others

description
    MZ62 series PTC thermistor is a self-protective,automatic recovery component for abnormaltemp. and current,is commonly called "self-recovery fuse""ten thousand fuse".It is instead of traditional fuse,widely used in over current protection for motors,transformer,and electronic circuit.PTC thermistor can limit the whole line dissipation to reduce the residual current by its resistor value changes abruptly.PTC can recover its protect function after removing the failure.But in traditional fuse circuit ,fuse can't recover after break

  To choose PTC as over load protect componentfirstly to confirm the max normal line working current or PTC's hold currentand PTC's fix placenormal working the max ambient temperaturesecondly is the protective currentor PTC's trip current )、the max working voltagerated zero power resistanceto consider the component's size at the same time as following diagram:the relation of operating environmenttemp.,the hold current,and the trip current

principle
    PTC's current is smaller than the rated currentPTC resistance value is in normal conditionthe value is very smallit can't affect the normal working of the protect circuitwhen the circuit is in failurethe current exceed the rated current greatlyPTC heat up abruptlyget into high value statelet the circuit in "off" stateso as to protect the circuit .After the failure is removed PTC's value recover to low resistance,the circuit recover to its normal condition

  Figure 2 is V-A curve  and load curve in normal workingfrom point A to B,PTC's voltage raised step by step PTC's current also linear increasing that is PTC's value don't change mainlyor it is in low resistance stateFrom point B to Ethe voltage raised step by stepas PTC is hot,  its resisort value increased abruptlyPTC's current lowed rapidlythat  PTC  is in protect stateThe normal load curve is lower than point BPTC isn't in protect state

There is 3 typies of overcurrent protect commonly


1
over currentfigure 3):RL1 is load curve in normal workingwhen reducing the load resistancesuch as the transformer circuit is shortthe load curve changed from RL1to RL2exceed point B PTC get into protect state

2
over voltagefigure 4):the power voltage increase such as from 220V to 380V suddenlythe load curve changed from RL1to RL2exceed point B PTC get into protect state

3
over heatfigure 5):when the ambient temp. raised to a certain limitPTC's V-A property curve is changed from A-B-E to A-B1-Fload curve RL exceed point B1PTC get into protect state


application

 

product list





the electronic parameter and size above only for reference,according to customer's need!

  


Clicks on the number:3899 Input time: 2007-2-5 【Printing】 【Closure
 
 
 
Dandong Guotong Electronic ©All rights reserved Tell:0415-6279502